3M Filtrete AP110 Replacement for 3M Aqua-Pure AP2005 - 2-Pack

The 3M Filtrete AP110 Replacement for 3M Aqua-Pure AP2005 - 2-Pack is designed with a grooved design and an exclusive graded density that allows for up to 30% longer life than most filters in its same class. This 5 micron water filter can withstand extreme pressure drops and stress such as water hammer.

Specifications:

• Brand: 3M Aqua-Pure
• Part Number: AP110
• Replaces Part Number: AP2005
• 3M ID Number: 7000029441
• Pack Size: 2
• Filter Life: 6 Months
• Micron Rating: 5
• Flow rate: 8 gpm
• Dimensions: 9 3/4" x 2 1/2"
• Operating Temperature: 100 Degrees

How do you install the 3M Filtrete AP110 Replacement for 3M Aqua-Pure AP2005?

1. A11T: Shut off inlet and outlet valves, depress pressure relief button on top of filter head to relieve pressure in filter. AP101T, AP141T and AP102T: Turn valve handle to “OFF” position. The inlet and outlet lines are now closed off from the filter chamber and the pressure has been released at the built-in vent port.
2. Unscrew housing to the left from the filter head and remove cartridge, emptying water from housing.
3. Clean and inspect all components. Lubricate o-ring with a silicone based lubricant. Replace o-ring seal if there is visible damage.
4. Install new 3M Filtrete AP110 cartridge into housing, over centering post if you have a two-high unit.
5. Place lubricated o-ring on the housing. Screw housing to the right firmly onto head until a definite stop is felt and cartridge is sealed. Hand tight is sufficient. However, be sure not to overtighten or force housing.
6. A11T: Turn on inlet valve and depress pressure relief button until air is purged from filter. Release button and turn on outlet valve. AP101T, AP141T and AP102T: Turn valve hand to the “ON” Position. Wait until filter is filled with water and check for leaks. Open and close the valve once to released trapped air. Allow a slight pause in the “OFF” position. Replace cartridge when there is a decided drop in water flow at the faucet or tap.

How often should you replace the 3M Filtrete AP110 Replacement for 3M Aqua-Pure AP2005?

• Changing your 3M Filtrete AP110 is a very quick and easy process that should be done once every six months.

What contaminants does the 3M Filtrete AP110 Replacement for 3M Aqua-Pure AP2005 reduce?

• The 3M Filtrete AP110 reduces the following contaminants:

  • Rust
  • Sediment